16-30 Twin City restoration.
Found some pretty good color on this dirt-caked side curtain bracket.
The crankshaft requires grinding, first step to getting it out was getting the flywheel off.
I lost some of my other pictures when the old site went down, I planning on putting them back up sometime this week.
12-11-09
12-10-09
12-09-09
Compressing the valve spring
Pulling out the keeper
Pulling out the first valve
The Valve seat right after I pulled
the valve out.
12-08-09
This is how the cylinders looked as soon as
I took the head off, not too bad! Just
a little bit of surface rust, but a lot of it
wiped right off with just a rag.
I took the gasket off, it came in one piece
without tearing at all.
This is all the junk I poured out of the
head's water passages, I think it might
get hot tanked, or some other kind of cleaning
I took the lugs off, the bolts were all quite
loose and the lugs pretty beat up.
12-07-09
This is what greeted me as I pulled the
exhaust manifold off
I poured all this out of the manifold.
